About Our Fittings

Emergency Conversions

Emergency conversions are available for most Cryselco Fluorescent luminaires. The advantages of using our fittings with factory fitted emergency lighting equipment include the peace of mind that comes with a guarantee that applies to the entire luminaire and factory fitted units installed under our quality assurance systems meeting the requirements of ICEL, BS and EN Standards.

Wherever possible the emergency gear will be housed within the luminaire (integral) but there are some cases (heat build up, physical size etc.) where it will be necessary to either use different control gear for the fitting or mount the emergency gear outside the luminaire in a remote box. The luminaire will be pre-wired ready for a simple on site wiring into the remote gear box which must be mounted within 0.5 metres of the luminaire. Most of our emergency conversions are maintained where one of the standard tubes will immediately restrike in the event of a complete mains supply failure and provide light for three hours.

In some cases although we list emergency add on options, please note that suitability for emergency conversion may not be possible. Please check.

Please refer to the Proteus and Meteor ranges for emergency conversions on these ranges.

Please Note: All references to emergency conversions relate to standard fittings. Please refer any enquiries for emergency conversions with dimming gear or sensors.

Other Information

All Cryselco fittings are High Frequency (HF).

All Cryselco fittings have branded European gear.

All Cryselco products comply with EC Directives and the quality standard conforms to BS EN ISO 9001.

We are members of Lumicom and fully comply with the Waste Electrical and Electronic Equipment legislation (the WEEE Directive) on recycling.

Our range is designed for use in the UK for normal indoor atmospheric conditions. All our fittings (unless otherwise stated) are for use with fluorescent tubes (which we do not supply).

Please note that high or low temperature extremes can affect the operation of fittings. Acceptable ambient temperature is 5°C to 35°C.

Tubes are not supplied with fittings.

Please note that unless specified, no fixing brackets are supplied with fittings as installation is left to the contractor on site.

In an attempt to continuously improve products, the company reserves the right to change the specification of any product without prior notification. This could affect photometric performance of fittings. Therefore please check with us that you are using the most up to date data for our fittings as previously issued data can become outdated and inaccurate.